A. check whether the display of the operation panel is normal, and observe whether the display of the panel is damaged, shallow or incomplete. If there is any abnormality, replace the panel or repair it in time.
b. 检查电源电压、输出电压、直流母线电压是否正常。用机械万用表分别测量三相电源电压,正常情况下应该平衡,电压值在正常范围内,单相的电源电压也在正常范围内。若U/V/W三相不平衡或输出电压偏低,应停机检修变频器。直流电压值过低(与监控值D-4/d0.007对比),也需检查修理。
B. check whether the power supply voltage, output voltage and DC bus voltage are normal. Use mechanical multimeter to measure the three-phase power supply voltage respectively. It should be balanced under normal conditions. The voltage value is within the normal range, and the single-phase power supply voltage is within the normal range. If the U / V / W three-phase is unbalanced or the output voltage is low, the inverter shall be shut down for maintenance. The DC voltage value is too low (compared with the monitoring value D-4 / d0.007), which also needs to be checked and repaired.
c. 检查输入输出电缆是否发热、变形、烧坏,如有此情况,通常是接线端子松动,需扭紧,或停机更换导线。
C. check whether the input and output cables are heated, deformed or burnt out. In this case, the wiring terminal is usually loose, which needs to be tightened, or the wire shall be replaced after shutdown.
d. 检查风扇运转是否正常,如不正常应停机后清理或更换之。
D. check whether the fan operates normally. If not, clean or replace it after shutdown.
e. 检查散热器温度是否正常(可用红外线测温仪测量)。如不正常,若是环境温度过高,应采取措施降低环境温度;若是风扇使用年限已到、堆积尘埃油污,致使散热器温度升高,则应清理或更换。
E. check whether the radiator temperature is normal (it can be measured by infrared thermometer). If it is abnormal, if the ambient temperature is too high, measures shall be taken to reduce the ambient temperature; if the service life of the fan has expired and dust and oil have accumulated, which causes the temperature of the radiator to rise, it shall be cleaned or replaced.
f. 检查变频器是否有振动现象。可用长柄螺丝刀一头触变频器,耳朵贴紧螺丝刀柄,可发现轻微的振动现象。该种现象通常是由机械振动引起的共鸣,会引起电子器件的机械损伤。可增加橡胶垫来减少或消除振动,或在确保精度准确的前提下,通过调整参数,避开机械共振点。
F. check the frequency converter for vibration. A long handle screwdriver can be used to touch the frequency converter at one end, and the ear is close to the handle of the screwdriver, so slight vibration can be found. This phenomenon is usually caused by mechanical vibration resonance, will cause mechanical damage of electronic devices. Rubber pad can be added to reduce or eliminate vibration, or on the premise of ensuring accuracy, mechanical resonance point can be avoided by adjusting parameters.
g. 检查变频器在运行过程中有无异味。
G. check whether the frequency converter has peculiar smell during operation.